CATALOGUE release 8.8

391 / 1278

Products designed for industrial applications.
General terms and conditions for sale are available on
1
Series RL rod lock MOVEMENT > CATALOGUE > Release 8.8
/10.10.01 1
MOVEMENT
Series RL
rod lock
For cylinders ISO 6431/VDMA and ISO 6432
ø 20, 25, 32, 40, 50, 63, 80, 100, 125 mm
Series RL rod locks are available in 9
different sizes (diameters: 20, 25, 32,
40, 50, 63, 80, 100 to 125 mm). The
compact dimensions allow units to be
fitted on cylinders where space is limited.
Rod lock units are often used to hold the
load in position during Emergency Stop
conditions or when the air supply may be
accidently disconnected from the system.
The holding forces are measured at 8
bar and apply in both directions.
Caution!
The rod lock should not be used to
“brake” the piston rod in dynamic
conditions and must only be applied
when movement has ceased.
Note:
the cylinder piston rod length must be
increased when using a rod lock unit.
See the table for the minimum extension
lengths for each diameter.
» » Compact design
» » Functioning in both directions
» » Blocks without pressure
releases with pressure
GENERAL DATA
Type of construction compact
Operation piston operated clamp
Materials housing: anodized AL
clamp: brass
seals: NBR
Cylinder diameter ø 20 - 25 - 32 - 40 - 50 - 63 - 80 - 100 - 125
Operating temperature 0°C ÷ 80°C (with dry air -20°C)
Configuration pressure release
Operating pressure 3 ÷ 8 bar
Ports M5 = ø20, 25, 32 - G1/8 = ø40, 50, 63, 80, 100, 125
Fluid Filtered air without lubrication. If lubricated air is used, it is recommended to use ISOVG32 oil. Once applied the lubrication should
never be interrupted.