255 / 266
238
The company reserves the right to vary models and dimensions without notice.
These products are designed for industrial applications and are not suitable for sale to the general public.
TECHNICAL DATA
Technical Data
10
NORTH AMERICAN FITTINGS & FLOW CONTROL VALVE CATALOG
>
Release 8.6
O-Ring Replacement for Camozzi Push-In Fittings
Camozzi Push-In Fitting – Collet Removal for O-ring Replacement/Exchange
CONFIDENTIAL – exclusive use by Camozzi and its authorized Distributors only.
Express consent granted by written permission of Camozzi Pneumatics, Inc. only.
1. Grip fitting evenly on non-thread, or non-sealing surfaces, (avoid gripping
places such as stem OD).
2. Grip collet evenly with pliers.
3. With an even and straight pulling
motion, pull collet out of body
parallel. ** Do not use a screwdriver
or making any prying motions at an
angle in removing the collet.
4. With a blunt pick or hook, pull (fish), out the oring from the oring gland seat.
** Take care to not scratch the inner surface of the body.
5. Check the inner surface/gland where the oring had been. Look for any
debris. If any debris or dirt, clean out before inserting new oring. ** If any
excessive scratches appear on the inner gland surface, (more than typical
machining marks), the fitting should be discarded.
6. Place new oring on the open body
throat. Insert the oring partially
down the body throat. Use even
pressure from your finger to insert
the oring in a flat position. ** Take
care that the oring is not twisted, or
slips vertically and falls down the
body cavity.